Bond HYUTT33001-1 Manual De Instrucciones página 4

SAFETY INFORMATION
Only use the regulator and hose assembly provided with this unit. Replacement parts must be supplied
directly by Bond Manufacturing Co.
Inspect the burner before use of this unit. If the burner shows any kind of damage, do not operate
the appliance. For assistance with repair or replacement of the burner or any other parts, calls Bond
Manufacturing at 1.866.771.2663.
NOTE: You must follow all steps to properly assemble this heating item. Make sure the gas
valve is turned "OFF" before assembling. Do NOT attempt to assemble without proper tools.
Min. Clearance
48 in (121.9 cm)
Min. Clearance
48 in (121.9 cm)
Min. Clearance
48 in (121.9 cm)
A table with an umbrella hole (not
included) is required to assemble
this product; shown to the right is
an example of a table with an
umbrella hole.
Before beginning assembly of product, make sure all parts are present. Compare parts with
package contents list and hardware contents list. If any parts are missing or damaged, do not
attempt to assemble the product.
Estimated Assembly Time: 20 minutes
Tools Required for Assembly ( not included): Phillips screwdriver
Bond Manufacturing Company | Page 4
Combustible materials should not be within 72
Min. Clearance
48 in (121.9 cm)
inches of the top of the unit, or within 48 inches
around the entire unit.