Orbegozo AP 1000 Manual De Instrucciones página 9

AP 1000
• The appliance must be supplied at very low voltage
corresponding to that marked on the appliance.
DEVICE START‐UP
Overview of the Components
1 Dust container
2 Dust container release button
3 Display
4 ON/OFF switch
5 Handle
6 Motor casing
Wall holder
Mount the wall holder with the supplied screws and dowels.
CHARGING THE BATTERIES
After mounting the wall holder:
Insert the AC adapter in a duly installed 230V/50Hz protective contact socket. The charging
•
LED lights up.
•
If you want to charge the batteries, first remove the nozzle attachments and then insert the
•
device first into the upper bracket of the wall mounting.
Then press the handle lightly until the device locks in place.
•
The charging time is approximately 16 hours the first time, and then approximately 8 hours.
•
Once the charging is over, unplug the AC adapter.
•
USING THE DEVICE
Unplug the device and fit on the desired nozzle.
•
In order to start vacuuming you have to press the ON/OFF switch (4) and keep it pressed.
•
Once you have finished or when the batteries are down, connect the vacuum to the charger
•
as described in "Charging the Batteries".
Make sure that the plug is inserted.
•
NOZZLES
Crevice nozzle: ideal for vacuuming corners and crevices, etc.
•
Use for wet vacuuming: Please ensure that you always use the attachment when
•
vacuuming up liquids (insert the extension of the attachment into the device until the nozzle
is flush).
7 Charger
8 Wall holder
9 AC adapter
10 Filter
11 Attachment for wet vacuuming
12 Crevice nozzle
9