Installation - Sony XAV-AX100 Manual De Instrucciones

Using the rear view camera
Installation of the rear view camera (not supplied) is
required before use.
The image of a rear view camera connected to the
CAMERA IN terminal is displayed when:
 the back lamp of your car lights up (or the shift
lever is set to the R (reverse) position).
 you press HOME, then touch [Rear Camera].

Installation

Mounting the unit in the dashboard
For Japanese cars, see "Mounting the unit in a
Japanese car" (page 26).
Mounting the unit with an installation kit
Before installing, make sure the catches on both
sides of the bracket  are bent inwards 3.5 mm.
1 Position the bracket  inside the
dashboard, then bend the claws outward
for a tight fit.

2
Mount the unit onto the bracket .

Note
If the catches are straight or bent outwards, the unit will not
be installed securely and may spring out.
26
GB
Larger than 
Catch
182 mm
Larger than 
111 mm

Mounting the unit in a Japanese car
You may not be able to install this unit in some
Japanese cars. In such a case, consult your Sony
dealer.

Bracket
Parts supplied with
your car
When mounting this unit to the preinstalled
brackets of your car, use the supplied screws  in
the appropriate screw holes based on your car: 
T for TOYOTA and N for NISSAN.
Note
To prevent a malfunction, install only with the supplied
screws .
Fuse replacement
When replacing the fuse, be sure to
use one matching the amperage
rating stated on the original fuse. If
the fuse blows, check the power
connection and replace the fuse. If
the fuse blows again after
replacement, there may be an
internal malfunction. In such a case, consult your
nearest Sony dealer.
To the dashboard/center console
Bracket
Fuse (10 A)
