Publicidad
Installation Instructions/Instrucciones de Instalación
Quick
Connect
2. Fill the soap bottle with liquid soap (make sure soap
viscosity is within recommended range).
3. Install the soap bottle into the mount/pump. Then
press and hold the Prime button until soap exits the
spout.
4. Place hands under spout and test the dispenser's
operation.
Adjust Quantity Dispensed
1. Remove the rubber plug in order to acces the
adjustment switches.
2. Remove the material covering the switches so
they can be moved.
3. Move the switches to the desired level of soap
quantity.
4. Push the rubber plug back into the access hole.
Warnings:
-Do not install the soap dispenser facing a mirror-like surfaces or other electronic systems operated by
an infra-red sensor
-Space for installation so that the user hands should not interfere with the soap dispenser sensor detection
area while operating a nearby faucet or other objects
-The soap bottle and control box must be accessible after installation
press and hold down
to slide hose in or out
1. With all components mounted plug in the electricity
sources and use the QUICK CONNECT to link the soap
line. Press the end of the QUICK CONNECT while sliding
the line in until it seats.
IMPORTANT: DO NOT ATTEMPT TO TIGHTEN OR LOOSEN
FITTING AT PUMP (FACTORY INSTALLED AND SEALED).
soap quantity
adjustment access
Prime button
Level 2
Level 1
(most soap)
Level 3
Level 4
(least soap)
5
wall
rubber plug
W AL L
LACAVA
Publicidad
