Publicidad
Installation Instructions/Instrucciones de Instalación
O-RING
GASKET
DISK
Connecting the Water Supply
1. Connect the flexible line to the water supply.
2. Make sure that the filter is installed between the flexible line and the
shut-off valve.
3. Turn on the central water supply. Open the shut-off valve.
4. Check for leaks.
Connecting the Power Source
1. Connect the power source:
a. For battery versions: install the battery box on the wall underneath the sink using the two sided adhesive.
The cable connection must point down.
b. For transformer versions: Plug the transformer into the electricity socket and connect the connectors.
2. Wait a few seconds before activation the faucet.
3. If the range is unsatisfactory, refer to "Range adjustment."
LACAVA LLC
Faucet Mounting Preparation
Shut off water supply and remove hexagonal nut, disk, and gasket. Do
not remove the O-ring from the base of the faucet.
1 1/8" - 1 3/8"
Ø 28 - 34
Installing the Faucet
1. Place the faucet with the O-ring into the hole in the deck or lava-
tory (Note recommended hole size in drawing). Make sure the O-ring
is between the deck/lavatory and the bottom of the faucet.
2. Slide the gasket over the flexible hose.
HEX. NUT
Shut-off
Valve
4
Flex
Hose
Filter
Publicidad
