Shelving Configurations - Lynx LM15WINE Mantenimiento Y Operación / Instalación

SHELVING CONFIGURATION
Shelving Configuration
Your Lynx Grills appliance is equipped with full extension
ball bearing shelf glides to provide maximum access and
visibility for the product stored on the shelving arrangement
listed below.
Single Zone Wine Cellar:
15" (38.1 cm) Wide models:
(6) 4 bottle wire racks
Locking tab
12
CARE AND USE/INSTALLATION
Remove the
wine from the
shelf to be
removed
Figure 14
Figure 14a
To Add or Remove a Shelf
CAUTION
!
Never try to remove a loaded shelf, remove everything from
the shelf before removing. Use both hands when removing
the shelf.
To remove a shelf:
Extend the shelf out of the cabinet until it stops.
Unload the shelf (see Figure 14).
Depress the locking tabs on both sides of the shelf and pull
the shelf straight out (see Figure 14a). When the shelf is
removed, push the extended cabinet mounted shelf exten-
sions back into the cabinet.
To re-install a shelf:
Pull out the cabinet mounted shelf extensions to assist the
engagement with the wire rack shelf.
Insert the wire rack side track into the cabinet mounted
shelf extensions on both sides.
Push the wire rack completely into the cabinet to engage
the locking tabs.
Pull the shelf out, (unloaded), to verify the wire rack is
locked into the side rails. If the wire rack falls out, the lock-
ing tabs are not engaged; repeat the installation.
Load the shelf as required.