Checks To Be Carried Out At Installation; Periodical Checks - Berkel BS+1650 T Manual De Uso

With the machine operating:
-
Check on the efficiency of the guards and safety devices; opening door or rest
tray of 5 mm at least the machine have to stop.
-
Check on correct alignment of the blade drive pulleys.
-
general operating check.
-
Repeated cutting tests to check correct machine set-up according to the type of
work required.
-
Check that the blade stop within 4 sec, if not contact the maintenance.
7.4 Check to be carried out at installation
To ensure that the machine has not been damaged during transport or installation,
the following checks should be carefully performed:
Before start-up:
-
Check that the power supply voltage corresponds to the value given on the ma-
chine rating plate.
-
Check that the warning and danger signs are fitted and in perfect condition.
-
Check correct tensioning of the blade.
Check with the machine operating:
-
Check the efficiency of the guards and safety devices. Transport could have
damaged or altered the setting.
-
Check that the cutting blade is correctly aligned.
-
Perform some cutting tests with pieces the same size as those to be cut by the
user.
7.5

Periodical checks

To ensure long-lasting reliability of your machine, in addition to the above, constant
checks and controls must be performed as follows.
Before beginning each shift:
-
check operation of the safety devices.
-
Check the condition of the blade. If not sharpened or not in perfect condition,
replace.
-
Check that blade stop within 4 seconds
-
Check tensioning of the blade.
-
Check alignment of the blade respect to the pulleys.
ATTENTION!
If the blade don't stop
maintanance
After each shift:
-
Thoroughly clean, eliminating all remains.
-
Slide out, clean and refit the blade guide.
within 4 sec. or for any other failures, contact the
25