Cleaning & Maintenance - HAEGER Ultra-Steam 2800 Instrucciones De Uso

English
3. Set the temperature regulator to the position MAX (•••).
4. When the iron warm up till the control light cuts off and lights up again, unplug the iron.
5. Hold the iron horizontally over a trap vessel.
6. Press the Self-Clean button and hold it in this position. Now steam and boiling water will start emerging from the steam escape holes at the
gilding sole. Any dirt, if present, will get washed out.
7. Release the Self-Clean button as soon as the water in the water container is used up.
8. To ensure that no water remains in the steam chamber, dry the gilding sole thoroughly. For this purpose, plug the iron and wipe the gilding
sole a few times on a towel or an old cloth.
9. Allow the iron to cool down before storing it away.
Emptying out the water tank
•
Take the plug out of the mains socket, open the lid on the filling spout and empty out the tank by holding the iron pointed-end down and
shaking it gently.
Storage
•
The iron can be stored away with the cable coiled up in the rear area. It is advisable to store the iron in the upright position with the water
tank empty and the steam regulator set to "0".
Cleaning & Maintenance
•
Avoid scratching the iron; do not pass it over hard surfaces. Traces of starch or sprays can be removed from the base by using damp cotton
wool or a non-abrasive cleaning product.
•
Do not put chemicals or detergents into the water tank.
•
The outside surfaces can be cleaned down with a damp cloth, without ever having to use abrasive agents or solvents.
6 Instructions for use