Video Settings; Wi-Fi Setting; Sensitivity Setting - Extel O’MOUV HD Instrucciones De Uso

VIDEO SETTINGS

This section allows you to confi gure the video quality and environment mode.
Video Quality
The Video Quality setting section allows you to adjust the quality of the video streaming. By selecting better
video image will allow you to view high resolution image. By selecting better streaming will allow the video to
display more smoothly (quality depend on local internet environment).
Only select better image when you have suffi cient bandwidth and updated mobile device(s). Please refer to P.4
for system requirment.
Environment Mode
The Environment Mode settings allows you to select the power line frequency used at the location of WAPP
camera. The power line frequency varies depending on geographic region. It may cause image fl icker if wrong
frequency is selected. Please check with local authorities for proper setting.
Low Light Enhancement
The Low Light Enhancement Mode is for improving the night view video image by providing 5 levels to select
from (5 = brightest).

WI-FI SETTING

The Wi-Fi setting allows you to choose the wireless connection and setup the Wi-Fi environment.
When you tap the "Manage Wi-Fi network" button, the system automatically scans the nearby network and
shows the available Wi-Fi routers in the drop-down list. Choose the appropriate Wi-Fi router and enter the Wi-
Fi router password if necessary. Due to security concerns, it is suggested to use the WPA/WPA2/ WPA2-PSK
protocol for Wi-Fi network.
Note:
1. When the Wi-Fi connection is completed and you unplug the Ethernet cable, the camera will reboot
and it will take several minutes to establish the connection. Please re-launch the APP when you see the
green signal indicator lights up.
2. The WAPP camera is designed to work with the legal Wi-Fi channels in your region
Please refer to your Wi-Fi router manual to choose an appropriate channel for WAPP camera.
3. If camera fails to connect to the Wi-Fi router, please hold down reset button for 2 seconds to reset the
system and repeat register process again.

SENSITIVITY SETTING

This defi nes the camera parameter for motion detection.
Detection Mode
PIR is hardware-based biomass detection.
SOFTWARE use advance software analysis to trigger motion alarm.
Motion Detection (available for Software Mode ONLY)
HIGH – Suitable for detecting smaller object(s) within 5 to 6 meters
LOW – Suitable for detecting larger object(s) within 3 to 5 meters
GB17
CFI EXTEL O'MOUV HD - 10/2015