Flex Zone - Samsung NZ36K7880U Serie Manual De Instrucciones

Flex zone

You can use the Flex Zone function to operate and control the two elements on the
left side simultaneously, as a single cooking zone, and then use the zone for large
cookware. (Examples: oval cookware, large spaghetti pots, etc.)
Flex zone Indicator
NZ36K7880U_DG68-00824A-00_EN+MES+CFR.indb 23
1. Touch the Flex Zone selector. The two
left elements are synched and will now
work together.
2. Use an element control as shown to
adjust the power level of the two left
elements. The power setting displays of
the two left elements (front and rear)
will change together.
To disable the Flex Zone function, touch
3.
the Flex Zone selector.
• You can also use the magnetic
knob to control the two elements.
See page 18.
The Flex Zone indicator uses pan detection
to display the active zone when the Flex
Zone function is enabled.
NOTE
If an inappropriate pot or pan is placed on
the cooking zone, the indicator blinks. If the
pot or pan is not removed, the cooking zone
turns off.
Any one element of the Flex zone may not
operate properly with a small pan or pot if
it slants to one element even slightly.
To turn the synched elements off, touch the
ON/OFF key for any synched element.
The two synced elements will turn off
simultaneously.
Size of pans
Induction cooking zones adapt automatically to the size of the bottom of the
cookware up to a certain limit. However the magnetic part of the bottom of the
cookware must have a minimum diameter depending upon the size of the cooking
zone.
Cooking zones Minimum diameter of the bottom of the cookware
Front or Rear Flex zone plus
Flex zone plus 9.4 inch (240 mm) (long side dimension), oval, fish
NOTE
5.5 inch (140 mm)
kettle
English 23
8/5/2016 2:01:39 PM