Halemeier S-Mitter Manual De Instrucciones página 3

S-Mitter
Typ: 12V = HA-ES-ESM-1
24V = HA-ESM-VH
Technical details
en
Wireless hand-held transmitter
Power supply:
Battery:
Battery life:
Transmission frequency:
Transmission range:
Stand-by current consumption:
Transmission operation current consumption:
Number of possible receivers:
Receiver 12VDC
Nominal voltage:
Switching capacity:
Load types:
Number of possible hand-held transmitters:
Channel allocation:
Reception frequency:
Connections:
Receiver 24VDC
Nominal voltage:
Switching capacity:
Load types:
Number of possible hand-held transmitters:
Channel allocation:
Reception frequency:
Connections:
Important Safety Informations:
1. During installation, maintenance and repairs the system must be completely disconnected from the mains electricity supply. Disconnect the mains plug and secure it
against being inserted again.
2. Only use approved installation materials or system accessories for mounting.
3. Damage caused by incorrect connection will invalidate warranty entitlement.
4. Cables should be installed in a way that connection points are not subjected to pull or tear.
5. To avoid hazards, any damaged external flexible lead of the light must only be replaced by the manufacturer or its designated customer care representative.
6. No warranty cover if unauthorized modifications are made.
Keep installation instructions in a safe place!
Please keep these installation instructions after installing the product so that any later changes can be carried out in the proper manner.
m
Do not dipose of in household waste! Disposal to be carried out in accordance with local regulations.
The wireless transmitter is immediately ready for operation with the receiver
contained in the set once the battery safety strip has been removed.
3
cM M 3 q
3 VDC
2x 1,5V AAA
ca. 8 months at average operation
433,9 MHz
Max. 30m in free field
10μA
10mA
unlimited; in 4 groups
depending on the radio range
12VDC
12VDC max. 36W
LED light
max. 5
automatic for transmitter programming
433,9 MHz
LED mini plug M1
24VDC
24VDC max. 72W
LED light
max. 5
automatic for transmitter programming
433,9 MHz
LED Multiplug MP2
2x 1,5V AAA
Dim (-)
Dims up to approximately 10%
1-4 memory locations
for personal colour setting
teach in/overwrite by
pressing and holding down the desired
button (approx. 4 seconds)
Halemeier GmbH - Lange Straße 51 - D 49326 Melle Neuenkirchen
m
channel „a" - „e"
for switching on and off
as well as for dimming
of the individual carnations
28
21,5
160 167
160 167
Transmission control LED
Master button
for full switching on and off of all channels.
Last switching status is saved.
short press - On/Off
Dim (+)
Dims up to 100%
16
160
45
16
160
45
/
25.394.02 18.12.2017