Shark DRAK Manual Del Usuario página 14

14 TEXTILE PARTS
A
C
REPLACING THE INTERIOR.
- Start the operation by sliding the plastic tabs
of the front of the head section in its housing
beginning with one side (Fig. A).
- Insert one end of the neck pad at the edge of
the helmet, and feed the remainder of the neck
pad beneath the edge of the helmet. Insert the
other edge of the neck pad at the other edge of
the helmet (Fig. B).
- Re-Engage the strap in its passers (fig. C).
- Then, hook the Velcro bands (Fig. D).
B
D
WARNING! The polystyrene lining and
interior padding are critical to properly
fit your helmet on your head. An improper fit
could cause your helmet to become dislodged
in an accident, leaving your head unprotected
and resulting in severe head injury or death. If
you are not sure that you properly replaced the
comfort padding, DO NOT USE YOUR HELMET.
Contact your retailer for assistance or advise.