Functional Description - Makita 3901 Manual De Instrucciones

SYMBOLS
The followings show the symbols used for tool.
V............................volts
A ...........................amperes
Hz..........................hertz
....................alternating current
.......................no load speed
.......................Class II Construction
.../min....................revolutions or reciprocation per
minute

FUNCTIONAL DESCRIPTION

CAUTION:
• Always be sure that the tool is switched off and
unplugged before adjusting or checking function on
the tool.
Adjusting the depth of cut
6 cutting depths can be preset according to the size of
biscuit to be used or if trimming the wall or ceiling panels
as explained later. Rotate the stopper until the pointer
points to the appropriate size marked on the stopper.
Refer to the table below for the correspondence between
the sizes marked on the stopper and the biscuit size.
Fine adjustments to the cutting depth can be made by
turning the adjusting screw after loosening the hex nut.
This may become necessary after the blade has been
resharpened a few times.
Size on stopper 0 10
Biscuit size 0 10
8 mm 10 mm
Depth of cut
(5/16") (0.4")
USD201-2
004574
1. Pointer
1
2. Stopper
3. Adjusting screw
2
3
20 S D
20 - -
12.3mm 13 mm 14.7mm
(0.48") (0.51") (0.58")
Angle guide
The angle guide can be moved up and down to adjust the
position of the blade in relation to the top of the work-
piece.
1
2
To adjust the angle guide height, loosen the lock lever
down and rotate the knob until the pointer points to the
desired scale graduation marked on the angle guide.
Then tighten the lock lever up to secure the angle guide.
The scale on the angle guide indicates the distance from
the top of the workpiece to the center of the blade thick-
ness.
Fence
The angle of the fence can be adjusted between 0° and
90° (positive stops at 0°, 45° and 90°). To adjust the
angle, loosen the lock lever and tilt the fence until the
pointer points to the desired graduation on the angle
scale. Then tighten the lock lever to secure the fence.
1
006423
MAX
-
When the fence is set at 90°, both the distance from the
20 mm
center of the blade thickness to the fence and the dis-
(0.8")
tance from the center of the blade thickness to the bot-
tom of the base are 10 mm (0.4").
4
004575
5
4
3
004576
1
2
3
4
004577
2
3
1. Lock lever
2. Angle guide
3. Knob
4. Scale
5. Pointer
1. Knob
2. Down
3. Up
4. Center of blade
thickness
1. Fence
2. Lock lever
3. Angle scale