Controls And Connections - Fenton FT8LED Manual De Instrucciones

CONTROLS AND CONNECTIONS

1. MICROPHONE VOLUME
Adjust the signal level of microphone
2. ECHO CONTROL
Adjust the intensity of the echo effect.
3. VOLUME
Adjust the overall output level of the portable
sound system.
4. CHARGE / FULL LED
LED indicator for battery loading or full battery.
5. MICROPHONE INPUT
6.3mm ¼" input jack for connecting a microphone.
6. LIGHT SWITCH
Turn on the LED (frontside) of the speaker on/off
7. POWER SWITCH
Turn the power on/off
8. POWER INPUT
Before connecting the power cord, check if the
mains corresponds to the voltage indicated on the
rating plate on the unit.
OPERATIONS INSTRUCTIONS
Make sure the volume control is minimal. Plug one end of the AC cord provided into the AC input jack (8) on rear side of the
portable sound system. Then plug the other end of AC cord into AC power outlet. Turn on the unit using the main power switch
(7).
Rechargeable Battery
This unit can be powered internally using the built-in rechargeable battery. When AC power is connected, CHARGE LED
indicator will light red. The rechargeable battery is being charged. If FULL LED indicator light green, the battery is fully charged
and ready to power the unit alone.
Turn off the power switch and disconnect the AC power. Turn the unit back "ON" and the rechargeable battery will power the
unit alone.
Note: Turning off the unit power switch will allow the battery to be charged more quickly.
ATTENTION:
Before the device the first time is actuated, please charge the battery at least 12 hours and max. 72 hours!
Battery should be regularly charged. For optimal battery life the battery should be charged at least 1x per month.
Please note that if you do not load within 6 weeks, the battery becomes defective !!
5