Using The Usb Port; Led Flashlight; Proper Disposal - Wagan Tech iOnBoost Slim Manual De Usuario

iOnBoost Slim by Wagan Tech
™

USING THE USB PORT

If the charge in the iOnBoost is low, the USB port will shut off to prevent damage to the iOnBoost.
Recharge the iOnBoost as soon as convenient.
1. Connect the USB device to the iOnBoost with a USB cable.
2. Turn on the master switch
3. Press the Power button to activate the USB port.
4. When your mobile device is fully charged, disconnect your device from the iOnBoost and
turn off the master switch.

LED FLASHLIGHT

If the charge in the iOnBoost is low, the light will shut off to prevent damage to the iOnBoost.
Recharge the iOnBoost as soon as convenient.
1. Turn on the master switch
2. Hold down the Power button for 3 seconds to turn on the light.
3. Short press to cycle through the lighting modes: 1=strobe, 2=S.O.S., 3=off or long press to
turn off from any mode.
4. Turn off master switch when done.
5. Recharge battery as soon as convenient.

PROPER DISPOSAL

• This product has no consumer serviceable parts.
• Do not attempt to remove or replace the battery used in this device. When
the battery has reached the end of its lifetime, please take the entire unit to a battery
recycling facility.
10
®
www.wagan.com