Assembly - Craftsman 917.248921 El Manual Del Propietario

1
BAGGER SUPPORT ASSEMBLY
Determine which type drawbar you have on your tractor.
Compare the drawbar illustrations below to the drawbar
located at the rear of your tractor.
Follow the support assembly instructions that apply to your
type drawbar.
DRAWBAR A
DRAWBAR A (See Figs. 1A, 1B & 1C)
1. Remove and discard the upper bolt on both sides of
the drawbar. Using the same holes, install the shoulder
bolts supplied and tighten securely.
2. Install adapter to both sides of support assembly as
shown.
DRAWBAR B
REMOVE AND DISCARD
UPPER BOLTS AND INSTALL
SHOULDER BOLTS SUPPLIED
DRAWBAR
FIG. 1A
ADAPTER
FIG. 1B

ASSEMBLY

3. Align support assembly pin with hole in drawbar and
hang assembly over the shoulder bolts.
4. Be sure support assembly is seated properly and secure
with retainer spring supplied.
SUPPORT
ASSEMBLY
DRAWBAR B (See Fig. 1D)
1. Discard adapters provided - not required for drawbar
type B.
2. Align support assembly pin with hole in drawbar and
hang assembly over the shoulder bolts.
3. Be sure support assembly is seated properly and secure
with retainer spring supplied.
SUPPORT
ASSEMBLY
RETAINER
SPRING
5
SHOULDER
BOLTS
RETAINER
SPRING
FIG. 1C
SHOULDER
BOLTS
PIN
FIG. 1D
PIN
3064