Assembling The And Telescopic Dome Shaft; Assembling The Telescopic Dome Shaft; Telescopic Dome Shaft On Which Persons May Walk; Telescopic Dome Shaft Over Which Passenger Cars May Drive - Graf PLATIN Instrucciones Para Montaje Y Mantenimiento

6.
6.1

Assembling the telescopic dome shaft

The telescopic dome shaft enables infinite adaptation of the tank
to given site surfaces with earth coverage of between 455 mm
and 655 mm (Mini telescopic dome shaft) or 455 mm and
755 mm (Maxi telescopic dome shaft).
For assembly purposes, the enclosed profile seal (material
EPDM) is inserted into the tank dome's sealing groove and is
coated generously with soft soap (do not use mineral oil-based
lubricants, as these attack the seal). The telescope is then
greased, inserted and aligned with the surface of the site.
„A"
6.2

Telescopic dome shaft on which persons may walk

Important: To prevent loads from being transferred onto the
tank, round-grain gravel
layers around the telescope
Damage to the tank dome
during this step. The cover is then positioned and is sealed to
prevent entry by children. Tighten the threaded connection
on the cover so tightly that it cannot be opened by a child!
6.3

Telescopic dome shaft over which passenger cars may drive

If the tank is installed under areas used by passenger cars, the
collar area of the telescope
supported with concrete
layer of concrete to be installed must be at least 300 mm wide
and approx. 200 mm high all around. The permitted coverage
above the shoulder of the tank is min. 700 mm and max.
1000 mm. There are different possibilities for lengthening the
tank dome (315 mm): telescopic dome shaft with cast iron lid
or Begu (max. effective length 440 mm) as well as the Adapter
(max. effective length 300 mm).
Attention: Use the cast cover under all circumstances.
6.4

BEGU telescopic dome shaft

On installation under areas used by cars with a maximum weight
of 3,5 t, the telescope
concrete rings  (diameter 600 mm) and a cast frame
star-shaped load distribution are then installed to support the
cast cover. (Observe earth coverafe of at least 700 mm, max.
1200 mm. The cast frame must have a contact area of approx.
1 m².

Assembling the and telescopic dome shaft


(max. grain size 8/16) is filled in in

and is evenly compacted.

and telescope must be avoided

(colour anthracite) must be

(load class B25 = 250 kg/m²). The

is supported as described in 6.3. The
mail@graf.info
www.graf.info
2

with
19 / 38
2
3
4
3
5
6
4
1
2
3
„A"
1
1