To Adjust Or Replace Brush, Troubleshooting Guide - Oreck XL U2000RB-1 Manual Del Usuario

T A
o djust or
WARNING: Unplug cord from
electrical outlet before servicing.
Rotate and match
bearing assemblies
IMPORTANT: Unless
the brush is worn as
indicated above,
both bearings must
be in the "NEW"
position. When
rotating, both
bearings must be in
the "OLD" position.
Unmatched settings
will cause damage
to your machine.
E N
R B
eplace rush
To determine if the brush is
worn, place a firm straight
edge across the nozzle
opening. If brush bristles
do not extend beyond
baseplate, brush should be
adjusted.
Remove the baseplate by
removing 5 screws. Then,
remove the belt and brush
roll from the housing.
Rotate both bearing
assemblies at ends of
brush roll to show "OLD"
and replace in the holding
channels in the housing.
NOTE: The bearing
assembly setting marked
"OLD" has two notches
( l l ) on the top of the
assembly. The one marked
"NEW" has one notch
( l ). When rotating
bearings, make sure both
bearing assembly settings
are the same and face up
when replacing the brush
roll.
Reassemble the belt and
the baseplate and check
bristle height above
baseplate at each end of
brush.
If a previous adjustment
has already been made
and bristle height does not
extend above baseplate, a
new brush assembly
should be ordered.
G L I S H
T
roubleshooting
WARNING: Unplug cord from
electrical outlet before servicing.
SAVE SERVICE CALLS...CHECK THESE FIRST:
• Is the disposable filter dust bag full?
• Are pores of filter dust bag clogged with powder or fine dust?
• Is anything clogging the revolving brush, lower tube, intake
opening, fan housing or connector assembly opening?
• Is the belt in place and turning the brush?
• Are the brush ends in the proper location?
• Does the brush turn freely? Are hair, string or rug fibers wound
around the brush?
P
ROBLEM
C
LEANER
WILL NOT RUN
C
LEANER
DOES NOT PICK UP
ALL OTHER SERVICING SHOULD BE DONE BY AN
ORECK AUTHORIZED SERVICE CENTER.
CALL COMMERCIAL CUSTOMER SERVICE HOT LINE
Commercial: 1-800-242-1378
Hospitality: 1-888-23-ORECK
Canada: 1-866-74-ORECK
Whenever calling, please be sure to have your model and
serial number from data plate.
7
G
uide
P S A
OSSIBLE OURCE REAS TO
Not plugged in Be sure cleaner is
properly. firmly plugged
into wall outlet.
No electricity in Check electrical
wall outlet. source–fuse or
circuit breaker.
Brushroll is
Clear obstruction.
jammed and
Upright can be
motor shut off.
reset by
unplugging or
switching the
ON/OFF button
once.
Filter bag is full. Replace filter bag.
See "To Install
Paper Filter Dust
Bag."
Clear obstruction.
Nozzle or intake
pivot clogged.
Brush is worn. See "To Replace or
Adjust Brush. "
Tube clogged. Clear obstruction.
Bag pores are Change bag.
clogged with fine
dust.
Impeller fan is Return to Service
broken. Center for repair.
Revolving brush is Check brush roll
not even at both end cards. Make
ends. sure words "old"
or "new" match at
each end.
C
HECK