What If There Are Problems; Replacement Parts And Wearing Parts; Disposal; Technical Data - Beurer MP 58 Manual De Instrucciones

6. What if there are problems?

Problem
Device will not switch on.
UV nail gel does not dry.
Nail varnish does not dry.
UV fluorescent tube does
not light up.

7. Replacement parts and wearing parts

Replacement parts and wearing parts are available from the corresponding service address (according to the service
address list). Please state the corresponding order number.
Designation
UV fluorescent tubes, 4 units

8. Disposal

Please dispose of the device in accordance with EC Directive – WEEE (Waste Electrical and Electronic Equip-
ment).
If you have any queries, please contact the appropriate local authorities.

9. Technical data

Model no.
Dimensions
Weight
Power supply
Nominal power
Permissible storage conditions
Number of UV lamps
UV lamp type
UV type of device
Switch-off times
Possible cause
Mains plug not plugged in.
No voltage at mains socket.
Treatment time with UV light too short.
Treatment time in dryer too short.
UV fluorescent tube not correctly in-
serted.
UV fluorescent tube faulty.
Item number and/or order number
163.290
MP 58
L 220 x W 210 x H 100 mm
1632 g
220 – 240 V, ~ 50/60 Hz
40 W
Store in a clean and dry place
4
UV-9 W-L 365 nm, 9 W
UV-A lamp type 3
90 seconds, 120 seconds, continuous operation
Solution
Insert the mains plug into the socket.
Check your fusebox.
Set a longer UV light treatment time.
Keep your varnished nails in the dryer for
longer.
Check that the UV fluorescent tube has
been correctly inserted.
Insert a new UV fluorescent tube.
12