Installing The Controller - Gardol GST-E 451 Manual De Instrucciones

1. Layout
Fig. 1:
1. Push bar
2. Adjustment lever for setting the spreading
volume
3. Spreader tank
4. Wheel

2. Installing the controller

Push bar
•
Fit the push rods into the spreader tank
(Fig. 2).
•
Fit the push bar on to the push rods (Fig. 3).
Adjustment lever
Fit the adjustment lever grip (Fig.1/ Item 2) to the
adjustment lever (Fig. 4/ Item A).
Foot
•
Remove the screw (Fig. 6 / Item B).
•
Insert the foot (Fig. 7 / Item 5) and secure it.
Wheels
•
Take the wheel caps off the wheels (Fig. 8).
•
Remove the screws (Fig. 9/ Item E) (on both
sides).
•
Attach the wheels (Fig. 10 / Item D) and se-
cure them.
•
Fit the wheel caps.
3. Operation
Insert spreader material
Important! Before inserting the material, always
set the adjustment lever (Fig. 5 / Item 2) to "0".
Recommended spreader settings
The spreader settings are shown in the attached
table.
Select the setting to suit other types of fertilizer or
sand and salt.
Anl_GST_E_451_SPK7.indb 8 Anl_GST_E_451_SPK7.indb 8
GB
The reprinting or reproduction by any other me-
ans, in whole or in part, of documentation and
papers accompanying products is permitted only
with the express consent of the iSC GmbH.
Subject to technical changes
- 8 -
27.08.15 16:37 27.08.15 16:37