English; Features Of The Unit; Refrigeration System; Description Of Its Components - Cornelius COR6519UBCSD Manual De Servicio

F
EATURES OF THE
Strong body with thick walls,
injected with CFC-free
polyurethane foam
Exterior cabinet and lining
made of galvanized, pre-
painted steel, with baked
polyester paint
Reinforced, heavy-duty,
adjustable dividers
Interior lining made of
acrylic-coated galvanized
steel for extra corrosion
resistance
R S
EFRIGERATION

Description of its components

Compressor:
The compressor is a factory-sealed unit located underneath (outside) the cooling cabinet. This pump is
activated by a motor which draws low-pressure vapor (refrigerant) from the evaporator. It then
compresses the gas and forces it into the condenser at a high pressure.
Starter relay:
The starter relay is attached on one side of the compressor box. The compressor motor has two
windings: one for starting and another for running. In order to provide for necessary additional torque
when the motor is first ignited, the starter relay connects the additional start-up windings. After the motor
reaches its correct operating speed, the relay opens the ignition windings and the motor carries on with
the operation windings.
Thermal protector:
This protector is a thermo-sensible device attached to one side of the compressor's box. In any given
situation, if the compressor overheats or the voltage source varies drastically, the thermal protector
opens, turning off the compressor. After the compressor cools down to a normal and safe working
temperature, the thermal protector turns on the compressor.
Condenser:
The condenser is located underneath (outside) the cooling cabinet in front of the compressor. It receives
hot, high-pressure refrigerant gas from the compressor and cools it down until it returns to liquid state.
© 2004, IMI Cornelius Inc.

ENGLISH

U
NIT
Sturdy, stainless steel top
Heavy-duty R-134a
condensing unit with easy
access for maintenance
YSTEM
FIGURE 1
- 1 -
COR6519UBCSD Service Manual
Rubber pull handle for easy
sliding of lids
Forced-air evaporator for
quick temperature pull-
down
Reinforced, 16 gauge
galvanized steel base
Forced-air condenser made
of copper and aluminum,
resistant to rust and saline
environments
Publication Number: 630460278SER