Publicidad
Idiomas disponibles
Idiomas disponibles
– Attach the hand wheel (21).
– Set the cutting height by turning the
handwheel to the required value.
Adjusting saw blade tilting
To make inclined cuts, the saw blade inclination
can be set steplessly between 0° to 45°.
DANGER!
Risk of injury!
Body parts or objects within the adjustment
range can get caught in the running saw
blade! Adjust the saw blade tilting only when
the saw bade is at a standstill!
• P. 7, item 12
– Release safety screw (20).
– Incline the saw blade into the required
position by turning the setting screw (19).
– Re-tighten the locking screw (20).
Note:
To be able to use the full adjustment range
of 45°, the cutting height must be reduced
accordingly.
Sawing
DANGER!
Risk of injury!
If the clearance between parallel stop and saw
blade is less than 120 mm, the slide rod
must be used. • Slide rod – page 10
DANGER!
Risk of injury!
Small workpieces cannot be held securely.
Only saw workpieces that you can hold
firmly.
DANGER!
Risk of injury!
The flap of the On/Off switch must be always
closed, even if the operation is interrupted
for a short while, in order to protect the device
against unintentional switching on.
• P. 7, item 12
– Attach the hand wheel (21).
– Set the cutting height by turning the
handwheel to the required value.
Adjusting saw blade tilting
To make inclined cuts, the saw blade inclination
can be set steplessly between 0° to 45°.
• P. 7, item 12
– Release safety screw (20).
– Incline the saw blade into the required
position by turning the setting screw (19).
– Re-tighten the locking screw (20).
Sawing
– Push the parallel stop (18) along the guide
rail to the front side of the saw bench.
The clearance from the parallel stop to the saw
blade can be read from the scale (35).
– Tighten the parallel stop by pushing the lever
(36) down.
– Push the cross stop (15) into the guide rail on
the left side of the saw bench.
The cross stop can be adjusted by a maximum
of 60° for mitre cuts.
– Loosen the locking screw (31), set the
required angle and re-tighten the locking
screw.
The set angle can be read from the scale (38).
– Set the cutting height of the saw blade (•
14
Publicidad
