Initial Setup - jbc MVE-A Manual De Instrucciones

Compatibility
Select the equipment that best suit your soldering or desoldering needs.
Module Stand
DS-SD
MVE-A
DR-SD
Initial Set up
For DDE Control Unit
1. After connecting the module, enter the
Peripherals Menu and select the port which
you want to join with the module.
2. Select the module from the list of peripheral
connections. Remember your first connection
is denoted as "a", the second being "b", etc.
(e.g. MV_a, MV_b,...).
3. Press Menu or Back to save changes.
For DME Control Unit
When a new module is detected, a pop-up
screen appears and proceed as indicated.
If no screen is shown, click on the icon
on the main bar and follow the steps.
For DME and DDE Control Units
Once set up, you can change the
module settings by entering the
Peripherals Menu.
Cartridge
Tool
Range
DS360-A C360
DR560-A C560
w w w.jbctools.com
Control Units
DDE DME
Peripherals
Pedal
Module
Module
MV_a
None
17:14
MODULE
Air pump
Install Postpone
Appears only when the installation is postponed
Peripherals
P-005
17:14
Port 2-DR
None
None
?
MENU
3 3 3