Using The Beverage Center; Storage Compartment; Manual Temperature Control; Removing The Wooden Shelves - SCHOLTES SBC NA Guia Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Using the beverage center

Storage compartment

The storage compartment's main function is that of
guaranteeing that your beverages are preserved in
optimal conditions.
The temperature has been set in the factory at a
temperature held to be excellent in most cases and
is 15°C=59°F in the upper compartment.

Manual temperature control

When you plug in your beverage center, the display
shows the temperature inside the beverage center: it
has been set to reach 15°C=59°F and become
steady on it. Should you need to adjust it, follow the
instructions below:
1. When you plug in your beverage center, the display
shows the temperature that has been set
2. Press the
button for one second (see the
Control Panel). The temperature will begin to blink.
3. Press the
or
buttons until you reach the
desired temperature.
4. Wait 5 seconds for the temperature to stop
blinking.
5. Wait until the beverage center reaches its
temperature before you place the beverage bottles
inside.
The inside light does not go on (or it goes off
temporarily) when the inside temperature goes over
24°C=75,2°F. This allows you to reach the pre-set
temperature more quickly.
*
The data is obtained by testing the product at a
room temperature of around 25°C=77°F.

Removing the wooden shelves

Follow the instructions below to remove the wooden
shelves:
1. Hold the front part of the shelf with one hand.
2. Slowly remove the shelf by pulling it toward you.
Pull out the shelf by 1/3 of the way if you need to
remove or replace bottles.
3. Remove or replace the bottles you need and push
the shelf back, making sure it locks into place.
4. Make sure the shelf is in place by trying to pull it
out once again. If it moves, push it back in again
until it is securely in place.
To completely remove the shelf, follow step 1 and 2
and remove all bottles that on the shelf. Slowly pull
the shelf toward you until you remove it from its
slots.
! Do not, under any circumstances, remove more
than one shelf at a time.
For a small number of bottles
If you do not need to store enough bottles to fill the
entire beverage center, we suggest that you divide
them up between the available shelves and that you
do not place them all on top or on the bottom.
Place the bottles in the centre of the shelves to see
them better from the outside.
EN
5

Publicidad

Tabla de contenido
loading

Tabla de contenido