Set-Up - Allmand PORT-A-LITE PAL 2000W4 Manual Del Operario

Ref
S Inner Mast

Set-Up

Preparing For Set-Up
Allmand Port-A-Lite® PAL 2000W4 / PAL 2500W4 portable
work lights are shipped in four cartons, and require assembly
before use. Upon receiving the Port-A-Lite®, remove each piece
from the shipping cartons and inspect the parts for damage.
Contact your dealer or Allmand if parts were damaged during
shipping.
Set-Up Instructions
1. Loosen the mast socket knob (A, Figure 3).
2. Insert the outer mast (B, Figure 3) in the socket, and tighten
the knob.
3. Make sure the inner mast (C, Figure 3) is completely
lowered. If additional lowering is needed, crank the mast
winch (D) counterclockwise until completely lowered.
4. Attach the light bar (E, Figure 3) to the inner mast, securing
with the light bar knob (F).
5. Remove the handle nuts (G, Figure 3) and flat washers (H)
from the studs (I) on the base assembly, leaving the plastic
washers (J) in place.
6. Place the center hole of each lamp fixture yoke (K, Figure
3) onto the stud on the base assembly, and secure with the
handle nut and flat washer removed in Step 5.
Note: Position the lamp fixtures onto the base assembly so they
face each other.
7. Install the handle (L, Figure 3) onto the front of the base
assembly, securing with the locking pin (M).
8. Coil the power cords (N, Figure 3) and lamp cables (O),
and secure with the hook and loop cable ties (P).
6
Description
3