Control Panel - Landxcape LX790 Manual Del Propietário

4. Control panel

Working time
START
Starts mowing/
Selects up
POWER ON/OFF
TM
Turns Landxcape on
and off
HOME
Sends Landxcape to its
charging base during
operation with the blades
rotating to cut grass
on the way home and
activates charging/Selects
down
Start
1) After the boundary wire installation, you can start using Landxcape
TM
2) Press until Landxcape
blinking. (The PIN code can be changed, please refer to "Setting" in the Installation Guide).
NOTE: Landxcape
TM
will turn off if it does not receive any input within 30 seconds after it is turned on. If you enter wrong PIN code three times,
TM
Landxcape will raise the alarm "di-di" and then turn off.
3) Press , then press to start mowing.
4) Press then to make Landxcape
TM
Landxcape will work continuously until reaching low battery power level and then it will return to the charging base. Once charging is complete,
TM
Landxcape will automatically resume mowing or it stay in the charging base according to the mowing schedule.
NOTE: When Landxcape
TM
turns on, all lights on the display will be illuminated and then turn off. Check if there is any light damaged. It is
recommended to shield the display with your hand when the outdoor light gets too strong.
EN
STANDBY PAGE:
TM
Landxcape is not in the
working hours.
turns on. For the first use, input the default PIN code 0000 by pressing
TM
go to the charging base, with the blades rotating to cut grass on the way home.
SLEEP PAGE:
The icon is displayed.
TM
Landxcape is fully charged and is
not in the working hours.
TM
(Please refer to Installation Guide for boundary wire installation).
LOCK
BATTERY CAPACITY
DISPLAY
Displays the state of your setting
OK
Confirms any setting
STOP
TM
Stops Landxcape during
operation
for four times when the number 0 is
13