Dryer Installation - Sears Kenmore 796.5112 61 Serie Instrucciones De Montaje

DRYER INSTALLATION

(See page 3 for washer instructions.)
5
Insert the T-clip of the 4 retainers into the dryer base
as shown. Press up on the back of the clip and pull
outward to lock into place.
6
Position dryer on top of the pedestal.
NOTE: Because of the weight of the dryer, two or more
people may be needed.
7
Make sure the holes on the pedestal align with the
holes in the appliance, then install 4 screws at each
corner to securely attach the appliance to the
pedestal.
NOTE: If the screws are not installed properly, noise
and vibration may result.
T-clip
Retainer
for washer
for dryer
for dryer
for washer
8
Move the dryer to the desired location.
NOTE: The appliance and pedestal assembly must be
placed on a solid and level floor for proper operation.
Adjust the legs of the pedestal using the wrench
supplied. Tighten the lock nuts with the wrench.
Lock nut
NOTE: If dryer was previously installed, uninstall it as
follows:
A. Uninstalling an electric dryer:
1) Unplug the power supply cord,
2) Pull the dryer away from the wall enough to loosen
the vent clamp. Loosen the clamp and carefully
remove the exhaust vent from the dryer exhaust
outlet.
B. Uninstalling a gas dryer:
1) Unplug power supply cord.
2) Turn off the gas supply.
3) Pull the dryer away from the wall enough to loosen
the vent clamp. Loosen the clamp and carefully
remove the exhaust vent from the dryer exhaust
outlet.
4
Adjustable feet