ACDelco ARM303-4A Manual De Instrucciones página 12

POWER OFF
Press C key and hold 3 seconds to switch off.
RESET
Press C key to reset (when device turned on)
HOW TO SELECT UNIT
Press U/S key to select N-m, Kg-cm, lb-in, and lb-ft; the preset unit is N-m.
1 lb-in
1 lb-ft
1 N-m
1 Kg-cm
MEMORY FUNCTION
All memory data sets are preset as the smallest value. To set a memory value, press the
M KEY, and the digit on the far right of the M-01 display will begin to flash; use ▲
(up) or ▼ (down) to select the memory data set (up and down keys can be held down
for continuous increasing or decreasing. Press the M Key after selected, will leave the
select mode to stop flash.
HOW TO SET TRACE MODE (F), PEAK MODE (K) OR ANGLE MODE (A)
TRACE MODE (F) (preset as trace mode at time of first use)
After setting a value (assuming the value is 50N-m), the force applied by the wrench
will gradually increase from 0000. When force is applied, the displayed value will
change as the user applies different amounts of force; the reading will increase as force
increased, and decrease as force decreased. The reading will jump to 50 N-m when the
user releases his grip and lets up.
PEAK MODE (K)
After setting a value (assuming the value is 50N-m), the force applied by the wrench
will gradually increase from 0000. When force is applied, the displayed value will
change as the user applies different amounts of force; the reading is the final torque
value. After the display flashes 10 seconds (no actions or buttons will be effective at
this time), it will automatic back to the original setting data or press the C key to return
to the selected value, or apply force again and the measured torque value will rise from
0000.
ANGLE MODE (A)
After setting a degree (assuming is 50°), the force applied by the wrench will gradually
1English1
Torque Unit Conversion Table
lb-in
1 0.083
12
8.851 0.737
0.868 0.072
English
lb-ft N-m
0.113
1 1.356
0.098
-11
Kg-cm
1.152
13.83
1 10.2
1