Control Panel; Before Using For The First Time - brim SW30 Manual De Instrucciones

Control Panel

Before Using for the First Time

CAUTION: To protect against electrical shock, do not immerse the Coffee Maker or allow power cord to
come into contact with water or other liquids.
1. Remove all packing material and labels from the inside and outside of the Coffee Maker. Place the unit
on a flat, clean surface.
2. Before preparing coffee, thoroughly clean the glass carafe with lid, removable filter holder and
permanent coffee filter in hot, sudsy water. Rinse and dry. Replace disassembled parts. See Care &
Cleaning Instructions for a detailed description.
3. Clean the inside of the Coffee Maker by brewing 2 full carafes of tap water. Do not add the permanent
coffee filter or ground coffee for this initial cleaning.
4. Lift to open the Coffee Maker lid. Fill carafe with cold tap water and pour into water reservoir at the
back of the unit. The water level indicator can be easily viewed from the right side of the unit.
5. Assure that the tray with drip tray cover are locked in the vertical position, in order to allow spacing
for the carafe to sit properly on the heating plate. In failure to do so, when pressing on "my carafe"
button, the coffee maker will not start the brewing process and will beep 3 times as a warning of the
wrong configuration. Place empty carafe on the warming plate.
6. Close the lid.
7. Plug the power cord into 120V/60HZ power supply socket, the background indicator will be
illuminated; "AM 12:00" will flash. Set the clock time using the HOUR & MIN buttons, press CLOCK,
it will beep to confirm the time. The back-lit indicator will go into sleep mode within 15 seconds and
will release a beep if no further buttons are selected.
8. Press the "my carafe" button. The indicator light in "my carafe" button will turn on and the coffee
maker will begin the brew cycle.
NOTE: To interrupt the brew process at any time, press the "my carafe" button once, the coffee maker
will beep, then the unit will turn to keep warm function and the LCD will display the TIME SINCE
BREW icon and 0:00 counting up, which represents the time since brew cycle finishes. To shut down
the unit, press the "my carafe" button once again, the unit will beep and the indicator light in
"my carafe" button goes out.
9. Upon completion of the brew cycle the machine will beep. Water will continue to flow for
approximately one minute, or until the filter is emptied. The coffee maker will go to the keep warm
function.
10. Press the "my carafe" button another time, the coffee maker will beep, and the indicator light and
TIME SINCE BREW icon will turn off. The heating plate will shut down and the current clock will
appear on the LCD instead of the time since brew.
NOTE: At the end of the first cycle, allow the unit to cool down and throw out the water.
11. Brew a second carafe of fresh water.
12. Please allow the unit to cool down before brewing your first carafe of coffee. Unplug for storage.
SO-311289_50002 BRIM SW30 Coffee Station IM.indd 11
11
2014-11-18 2:30 PM