Preparing The Fuel - Echo PPF-236ES Manual De Instrucciones

Before you start
Saw chain tension adjustment
Correct cold ten- Chain needs ten-
sion sioning
Side link contact- Drive link tangs
ing guide bar hanging out of
guide bar

Preparing the fuel

Do not fuel up while the engine is hot or in operation.
Do not smoke or hold a flame near when refuelling.
If you do so, the fuel could ignite and cause fire, leading to burns.
Always disconnect spark plug cap before servicing cut-
ting attachment. Wear gloves when handling saw chain,
otherwise serious personal injury may result.
1. Move stop switch to STOP position.
2. Disconnect spark plug cap.
3. Loosen two gearcase cover nuts (A) until finger tight.
4. Hold the bar nose up, and turn the adjuster screw (B) clock-
wise until the chain fits snugly against the underside of the
bar, as shown. Cold chain only - turn adjuster screw clock-
wise an additional 1/8 - 1/4 turn.
5. Tighten both gearcase cover nuts with nose held up. Tighten
rear nut first.
6. Pull the chain around the guide bar by hand. Reduce the
chain tension if you feel tight spots.
7. When chain is properly tensioned, tighten gear case cover
nuts securely.
Tighten gearcase cover nuts to 8 - 9 N·m (71 - 80 in. lbs.)
Do not over-tighten nuts. Damage may result.
8. Keep chain properly tensioned at all times.
All chains require frequent adjustment.
9. Connect spark plug cap.
Correct warm
tension
Three mm (1/8")
between side
link and guide
bar at bottom
DANGER
10
WARNING
IMPORTANT
NOTE