SmartGyro Ziro 2 Manual Del Usuario página 30

EN
Charge connection:
Charging the smartGyro
Make sure that your smartGyro's charger is in optimal condition. Check
that there is no dust or dirt in the connector and if so, clean it and make
sure it is dry.
Always use the original charger provided with the product and connect it
correctly to the device (through the charging port) and to a power outlet.
It is important that you always use the charger that comes with your
smartGyro, otherwise the device may fail and may not be covered by the
warranty. Once the product is loaded, it will take approximately two or
three hours to complete the charge.
When the LED light turns green, it means that the product is fully
charged. It is important that at that time, I desco
immediately negate the network adapter so that it stops charging. The life
of the battery will be affected by the battery charging time, never exceed
and extend the life of your battery.
29
Remove the rubber cap, insert the charging cable. Once
the loading is done, put the rubber cover back in its
place.