HAMPTON BAY Havana Guía De Uso Y Cuidado página 10

Assembly - Attaching the Fan Blades
8
Mounting the fan
WARNING: When using the standard ball/downrod mounting, the
tab in the ring at the bottom of the mounting bracket must rest in
the groove of the hanger ball. Failure to properly seat the tab in
the groove could cause damage to the wiring.
□
Align the locking slots of the ceiling canopy (C) with the two
screws (LL) in the slide-on mounting bracket (A). Push up to
engage the slots and turn clockwise to lock in place.
□
Firmly tighten the two mounting screws (LL).
□
Install the remaining two mounting screws (JJ) into the holes
in the canopy (C) and tighten firmly.
□
Install the decorative canopy ring (N) by aligning the ring's
slots with the screws in the canopy (C). Rotate the canopy
ring (N) clockwise to lock in place.
A
10
Fastening the blade assemblies to
the motor
WARNING: Remove the rubber motor stops (PP) on the bottom
of the fan before installing the blades or testing the motor.
WARNING: Remove the rubber plug (QQ) on the black bracket
(RR) below the motor in order to attach the blade assembly
to the motor. Replace the rubber plug (QQ) to prevent water
from entering the switch housing and to reduce the risk of fire,
electric shock, or other personal injury.
□
Fasten the blade assembly to the fan-motor assembly (D)
by inserting the alignment post into the slot on the bottom
of the motor and tightening the blade bracket (H) screws.
The blade bracket screws are pre-installed into the blade
bracket (H).
□
Repeat this step for the remaining blade assemblies.
9
Attaching the blades to the blade
brackets
□
Attach a blade (G) to a blade bracket (H) by inserting blade
attachment screws (AA) into the holes in the blade (G) and
through the blade bracket (H). Note that the rubber washers
are preattached to the blade bracket.
□
Tighten each screw securely.
□
Repeat these instructions for each blade (G) and blade
bracket (H).
LL
N
C
D
D
PP
10
G AA
H
H
QQ
RR