How To Use Your Cb - PRESIDENT TEDDY II Manual Del Usuario

4) BASIC OPERATIONS TO BE CARRIED OUT BEFORE USING YOUR
SET FOR THE FIRST TIME (without transmitting and without
using the «push-to-talk» switch on the microphone)
a) Connect the microphone,
b) Check the antenna connections,
c) Turn the set on by turning the volume knob VOL (1) clockwise,
d) Turn the squelch SQ knob (3) to minimum (M position),
e) Adjust the volume to a comfortable level,
f) Go to Channel 20 using either s/t keys (2) or the UP/DN knobs
(9).
5) ADJUSTMENT OF SWR (Standing wave ratio)
WARNING: This must be carried out when you use your CB radio
for the first time (and whenever you re-position your antenna). The
adjustment must be carried out in an obstacle-free area.
* Adjustment with external SWR-meter (e.g. TOS-1 PRESIDENT)
a) To connect the SWR meter
- Connect the SWR meter between the CB radio and the antenna
as close as possible to the CB (use a maximum of 40 cm cable,
type President CA-2C).
b) To adjust the SWR meter
- Set the CB on channel 20.
- Put the switch on the SWR-meter to position FWD (calibration).
- Press the «push-to-talk» switch on the microphone to transmit.
- Bring the index needle to t by using the calibration key.
- Change the switch to position REF (reading of the SWR level). The
reading on the Meter should be as near as possible to 1. If this is not
the case, re-adjust your antenna to obtain a reading as close as
possible to 1. (An SWR reading between 1 and 1.8 is acceptable).
- It will be necessary to re-calibrate the SWR meter after each ad-
justment of the antenna.
WARNING: In order to avoid any losses and attenuations in cables
used for connection between the radio and its accessories, PRES-
IDENT recommends to use a cable with a length inferior to 3m.
Your CB is now ready for use.
B) HOW TO USE YOUR CB
1) ON/OFF - VOLUME
a) To turn the set on, turn the VOL knob (1) clockwise.
If the KEY BEEP function is activated, 4 tones sound when you turn
the CB radio on. See § KEY BEEP page 35. Display briefly shows
the frequency band (see § F - FREQUENCY BAND SELECTION page
35).
See FUNCTIONS TURNING ON THE UNIT on page 34.
b) To increase the sound level, turn the same knob further clockwise.
2) CHANNEL SELECTOR: s/t keys on unit
These keys allow increasing or decreasing a channel. A «beep»
sounds each time the channel changes if the KEY BEEP function
is activated. See § KEY BEEP page 35.
See also § 9 page 34.
2a and 2b) VOX ~ VOX SET
VOX
(short press)
The VOX function allows transmitting by speaking into the original
microphone (or in the optional vox microphone) without pressing
the PTT switch (8). The use of an optional vox microphone con-
nected to the rear panel of the transceiver (D) disables the original
microphone.
Press simultaneously the s key (2a) and the t keys (2b) on the
unit in order to activate the VOX function. «VOX» appears on the
display. A new press on these key disables the function, «VOX»
disappears.
VOX SET
(long press)
1. Long press simultaneously the s key (2a) and the t keys (2b) on
the unit to enter the VOX SETTING. "VOX" blinks, the current setting
and its value appear on the display. Three parameters allow to
adjust the VOX: Sensitivity: L / Anti-vox level: A / Vox delay time: t.
32