Impecca IPAC-08K Manual De Usuario página 9

InsTAllATIon InsTRUCTIons:
WInDoW slIDeR KIT InsTAllATIon (oPTIonAl):
Your window slider kit has been designed to fit most standard vertical
and horizontal window applications, However, it may be necessary for
you to improvise/modify some aspects of the installation procedures for
certain types of windows . Please refer to Figure K & Figure L for minimum
and maximum window openings . Window slider kit can be fixed with a
bolt (see Figure M) .
WInDoW slIDeR sIzInG ChART
Use the following chart to determine minimum and maximum gap sizes
for exhaust installation within windows . If the window opening is shorter
than the noted minimum length of the window slider kit, cut the slider
kit to the appropriate length . NEVER cut the kit shorter than the hole .
Type I
Type II
• A columns correpsond to minimum size
• B columns correspond to maximum size
InsTAllATIon In A DoUBle-hUnG sAsh WInDoW:
1 . Cut the foam seal (adhesive type) to the proper length and attach it to the window
stool . (see Figure N)
2 . Attach the window slider kit to the window stool . Adjust the length of the window
slider kit according to the width of window, shorten the adjustable window kit
if the width of window is less than 26 .5 (Type I) or 22 .1 (Type II) inches Open the
window sash and place the window slider kit on the window stool . (see Figure O)
3 . Cut the foam seal(adhesive type) to the proper length
and attach it on the top of the window . (see Figure P)
4 . Close the window sash securely against the window .
5 . Cut the foam seal to an appropriate length and seal the open gap between the
top window sash and outer window sash . (see Figure Q)
A a
67 .5 cm 2 .22 ft .
56 .2 cm 1 .84 ft .
B b
123 cm 4 .04 ft
98 .2 cm 3 .22 ft
7