Midwest Pet Gate 2929SG-WD Instrucciones De Montaje página 3

ASSEMBLY INSTRUCTIONS
For Installation Without Extensions
1. Locate the 4 threaded spindle bolts. Before you begin,
turn the adjustment wheels clockwise until they are
close to the plastic pads. NOTE: The adjustment wheel
should not touch the pad. If it does it could get stuck.
2. Insert the 4 threaded spindle bolts into the holes of the
plastic inserts in the four ends of the gate frame as
shown. NOTE: The plastic inserts are not threaded.
The threaded spindle bolts should slide into the inserts
without any resistance. P ush the threaded spindle
bolts all the way in until each adjustment wheel hits the
gate frame.
Positioning and Attaching the Mounting Cups to the Opening
Your gate is a pressure-mounted gate, therefore it is not necessary to use the mounting cups. However, using the
mounting cups will affix your gate more firmly in the opening, so you may choose to use them in all applications. If
you choose not to use the mounting cups, you may skip to Step 4 now.
3. Before attaching your mounting cups to the opening,
make sure you have correctly marked the placement
of the screw holes.
NOTE: It is important to install the gate with a spacing
of no more than .20" from the floor, and to make sure
the gap between the side walls and the gate is no
more than 2.5" on each side of the gate.
Position your gate in the opening so it is level and
centered as shown. Place the mounting cups over the
pad of the threaded spindle bolts, which should
already be fully inserted into the ends of the gate. Pull
the threaded spindle bolts out until the pad and
mounting cup is against the wall. Take a pencil and
make a light mark on the wall around the perimeter
of the mounting cup.
Repeat with the three remaining spindle bolts and
mounting cups. Once you have marked the correct
spots on your walls, move the gate aside.
Adjustment
Wheel
≤ 2.5"
Plastic
Pad
≤ 2.5"
≤ .20"
3