ACDelco ARL636 Manual De Instrucciones página 8

INSTALLING OR REMOVING BATTERY PACK
TO REMOVE THE BATTERY PACK: Depress the battery release button (6), and pull
battery pack (7) out of tool.
TO INSTALL THE BATTERY PACK: Align the rails, on the tool with the four tabs
on the battery pack, and push battery pack into the tool until it locks in place.
NOTE: Make sure your battery pack is fully charged.
CAUTION
POWER ON / OFF
Press the switch (4) for on/ off function.
SWIVELING HEAD
The flashlight can be used as a standing model or as a handhold model.
1. Hold the swiveling head (1) in one hand and hold the back end of the flashlight in
the other.
2. Swivel the swiveling head (1) up and down until it clicks into position which you
needed.
3. If required, swivel the head back into its original position.
MAGNETIC BACK (2):
1. Magnetic back allow the operator place the tool on any magnet surface.
2. "Hands-free use" let the operator more convenient to use at the situation that there
are no free hands to handle the tool.
WARNING
1English1
ASSEMBLY
Always set switch (4) to off position when installing and
removing battery pack.
OPERATION
MAINTENANCE
Remove the battery pack from this tool before cleaning solutions.
English -7