Uninstallation; Hardware Installation; Hardware Installation For Pci Card - Atlantic NetFly UP WN Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

3.2 Uninstallation

To uninstall the Wireless USB/PCI Adapter/Adapter, go to the Control Panel of your
system.
Open the Add/Remove Programs.
Select the Ralink Wireless Lan Card in the Add/Remove Programs and
then click on the Remove.
Click on Remove ALL [or Overwrite the older version install without
remove].
Then chose Yes, I want to restart my computer and click Finish.
Now You can remove the Adapter/Card.

4. HARDWARE INSTALLATION

4.1 Hardware Installation for PCI Card

The setup of the Wireless LAN Card can be performed using the following steps:
Shut down the computer, unplugs its power cord, and remove the chassis cover.
Insert the contact edge of the NetFly card into the connector of any available
PCI Bus Master expansion slot or PCI Express. Press the card firmly into the
connector such that the card's contacts are fully seated in the connector.
Install the bracket screw and secure the card to the computer chassis.
Visually inspect the PCI/PCIe Adapter and make sure that it is fully plugged in to
the PCI/PCI Express slot.
Cover the computer's chassis.
Switch computer power on.
The OS will start an automatic hardware discovery procedure in order to find and
install the best driver available for the device.
52

Publicidad

Tabla de contenido
loading

Tabla de contenido