Medisana AD 630 Instrucciones De Servicio página 13

Functions
The aroma diffuser is a modern fragrance diffuser which uses ultrasound technology to generate a
fine mist and thus distribute the fragrance throughout the whole room. The aroma diffuser has the
following additional functions:
■ Timer: The timer can be used to switch off the diffusion of the fragrance after a selected period.
■ LED: LEDs are integrated into the aroma diffuser which either light up in the selected colour or
change colour automatically.
Operating buttons
The aroma diffuser has two operating buttons which are used to control it. Each push of a button is
confirmed by a short beep.
Button Function
Switching on/off and the timer button:
This button can be used to switch the aroma diffuser on and off. You can only switch on
when the water tank is correctly filled.
In addition, the button can be used to set the timer for automatic deactivation of the
device. The current setting is visible in the display above the button. The following set-
tings are available:
1 hour → 2 hours → 3 hours → On → Off
LED button:
By pressing the LED button repeatedly, you can change the colour of the LED lighting on
the base of the device.
The following colour settings are available:
Alternating colours → Single selected colour → Dimming of the selected colour.
The colour sequence is orange, green, blue, red, yellow, shocking pink, light blue and
pink → Off.
Cleaning and servicing
■ To spare the device, switch it off for at least 60 minutes after three hours of continuous operation.
■ Before cleaning, pull the mains plug.
■ Empty the device via the drain side after each use and dry the water tank with a cloth.
■ Wash the water tank with clear water when you wish to change the aroma. This prevents mixing
different aromas.
■ Only clean the outside of the device with a soft, slightly damp cloth. Then rub it dry with a soft, dry
cloth.
■ Do not under any circumstances us brushes, sharp cleaning implements, benzene, thinners or
alcohol.
Art. 60084
For use
GB
13