Display Controls - Hisense HWS54029SS Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Display Controls

Standby key
Light On/ Off key
°F and °C Change key
Display
The control panel, shown above, is at the top of
the Refrigerator Chamber.
•Each time the power turns on, the display panel
will light everything for 3 seconds, beep for 1
second, and then enter the normal display status.
•Icons are always lit (until the screen activates).
•The display will activate the screen saver if no
button and no action is taken to open or close the
door for 60 seconds with the display on.
•Any button press or open door action will exit the
screen saver.
•Press the key in the screen saver state. Activate
the screen saver only. Do not change the settings.
•Each valid button press emits a short sound.
•The corresponding temperature setting is
reflected in the display, and the setting takes effect
and is stored after 10 seconds of operation without
pressing the key.
Standby Mode
When you do not plan to use this appliance for a
period of time, you can save energy by entering
the standby state.
•To enter standby mode, press and hold the
standby key for more than 3 seconds. The buzzer
will beep and the display board will show "OF".
•To exit standby mode, press and hold the standby
key for more than 3 seconds. The buzzer rings will
beep.
NOTE: In standby mode, cooling will stop. If you do
not to use the appliance for a long time, take out
the wine, and unplug the unit.
"Light On/Off key"
You can turn the interior light on or off by pressing
this button. After closing the door for 10 seconds,
the light will turn off automatically, so wine is not
exposed to light for too long.
A
B
C
Temperature Indicator
G
D
Temperature Measure Change (°F / °C)
You can change the temperature display setting
from Fahrenheit to Celsius degrees by pressing the
marked ,and vice versa.
Temperature regulation
You can set the temperature you desire by pressing
the buttons "
for the first time, the LED readout will show the
previously set temperature. The temperature will
increase 1°C or 1°F each time you press the UP
button and will decrease 1°C or 1°F each time you
press the DOWN button.
NOTE:
•The appliance doesn't work properly if the set
temperature is higher than the ambient
temperature.
•The temperature range is from 5°C(41°F ) to 20°C
( 68°F).
•The temperature preset at the factory is12°C.
•When you set a temperature, you set an average
temperature for the whole cabinet. There may be a
2°C to 3°C variance between the top and bottom
shelves of the appliance.
E
Cancel alarm key
F
Temperature control key -Down
Temperature control key -Up
" or "
". When you press the button
9

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Tabla de contenido