HOW TO USE YOUR
ELECTRIC KETTLE
HOW TO USE:
1.
Open the lid by pressing the Lid Lock Release Button (Figure 1).
Fill the kettle with water. Fill the kettle to the desired level. Do
not overfill. Be sure not to exceed the MAX line. To close the
lid, push down until it snaps into place.
2.
Always place the 360° swivel base on a flat, level surface.
3.
Place the kettle onto the 360° swivel base (Figure 2).
Check if the voltage at your location is the same as that
of the kettle. Details can be found on the label on the base of
the kettle.
4.
Switch the kettle ON by pressing the Power Switch (Figure 3).
IMPORTANT: Never open the lid while water is boiling.
5.
After boiling, the kettle switches off automatically. Disconnect
the kettle from the electric supply.
Warning: Take caution when opening the lid, the water is
very hot. Wait a few minutes for condensation to evaporate.
After boiling water, the outside of the kettle can be very
hot. Only grasp by the handle. Do not try to lift kettle body
with both hands. Do not open the lid when pouring
If the kettle is overfilled, boiling water may be ejected. The
kettle is only to be used with the base provided.
www.maxi-matic.com
4
Figure 1
Figure 2
Figure 3
info@maxi-matic.com