Far Tools RBS 250 Traduccion Del Manual De Instrucciones Originale página 29

FIG. F
Blade setting
01
- Blade positioning on wheels.
- Blade tension setting
- Upper guiding block side block and backstop setting.
- Lower guiding block side block and backstop setting.
Set the cutting to 90°
02
Functions of the machine
FIG. E
Start-up and shutdown
01
Cutting height setting
02
Table orientation
03
Guide operation (90°/45°)
04
How to change speed (113292)
05
Replacing consumables
FIG. G
Blade replacement
01
Belt replacement
02
Cleaning and maintenance
Always use a suitable blade for the material that is not damaged.
01
Each time the blade is replaced, check the settings.
02
When idle, slacken the blade tension slightly to relieve the strain on the machine.
03
Do not use for cutting firewood
04
Check that the wood does not contain any metal parts (nails, screws, etc.) liable to damage
05
the blade.
113291-Manual-E.indd 29
Connection to an extractor
06
-
07
Belt tension (113292)
08
Circular cutting
09
-
10
Wheel rubber binding replacement
03
© FAR GROUP EUROPE
EN
27/02/13 8:42:26