Design Features - Rockford Fosgate POWER T10001 bd Instalación Y Funcionamiento

D F
ESIGN EATURES
5
5 6 7 8 9 10 11 12 13 14
5 6
1. Power LED (Top of unit) – This Blue LED illuminates when the unit is turned on.
2. Thermal LED (Top of unit) – This Red LED illuminates if the amplifier reaches the third stage of
thermal protection.The amplifier will shut down to cool if this occurs.
3. Protect LED (Top of unit) – This Yellow LED illuminates if a short circuit or too low of an impedance
is detected at the speaker connections.The amplifier will automatically shut down if this occurs.
4. Fuses – These ANL fuses are easily accessible in case of failure.Always replace fuses with same type and
rating. See Specifications for fuse ratings.
5. 3-Stage Convection Cooling – The 3-stage thermal design consists of a 3-speed variable fan, integrated
PCB plenum and focused mass heat distribution utilizing a highly efficient cast aluminum heatsink.This
superior design keeps the amplifiers internal components cool, maximizes the amplifier potential, reduces
distortion and increases efficiency.
6. Speaker Terminals – The heavy duty, nickel-plated clamp wire connectors ( + and -) will accept wire
sizes from 8 AWG to 18 AWG.
WARNING:RISK OF ELECTRIC SHOCK. Use extreme caution when handling or
making speaker connections.The voltage at the speaker terminals can cause
injury or death. Always ensure the amplifier is off or disconnected from
power prior to making any type of speaker connection.
4
7 8 9 10 11 12
1
2
3
15 16 17
14 15 13
4
16 17