Reassemble The Cpu Mount - StarTech CPUWALLMNT Guia Del Usuario

Tabla de contenido

Publicidad

Reassemble the CPU mount

1. Take the washers that you removed when you disassembled the CPU mount and
thread them onto the bolts in the front bracket.
2. Place the bolts in the front bracket into the slots in the rear bracket.
3. Measure the width of the CPU that you're mounting.
4. Slide the front bracket along the slots in the rear bracket until the CPU mount is the
width of your CPU.
5. Thread the thumbscrews onto the bolts on the bottom of the CPU mount, and
tighten them into place. (figure 7)
figure 7
Instruction manual
Rear bracket
8
Front bracket
Thumbscrew

Publicidad

Tabla de contenido
loading

Tabla de contenido