General Guidelines; Cleaning And Maintenance - Velleman HQ-Power HQPE10003 Manual Del Usuario

3.

General Guidelines

Refer to the Velleman

This device is designed for professional use on stage, in discos, theatres, etc. The device should only
be used indoors with an alternating current of max. 230 V~, 50 Hz.

Snow machines are not designed for permanent operation: regular operation breaks will prolong their
lives.

Do not shake the device. Avoid brute force when installing or operating the device.

Familiarise yourself with the functions of the device before actually using it. Do not allow operation
by unqualified people. Any damage that may occur will most probably be due to unprofessional use
of the device.

Use the original packaging if the device is to be transported.

All modifications of the device are forbidden for safety reasons.

Only use the device for its intended purpose. Other uses may lead to short circuits, burns,
electroshocks etc. Using the device in an unauthorised way will void the warranty.
4. Overview
Refer to the illustrations on page 2 of this manual.
1 on-off switch
2
fuse
3
power input
5. Installation

Select a location where the device is protected against extreme heat, dust and moisture. Ensure a
minimum distance of 0.5 m between the device and any nearby surface or passer-by.

Install the device on a flat and stable non-slippery surface.

Use an appropriate safety cable to fix the device (e.g. VDLSC7 or VDLSC8) when mounted overhead.
6. Operation
1. Connect the device to the mains and switch on. The device is ready for use.
2. The device will automatically produce artificial snow. Note that the snow output is fixed and cannot
be adjusted.
3. Switch off after use, disconnect from the mains and let the device cool down. Remove any fluid from
the tank before storing.
7.

Cleaning and Maintenance

Before starting any cleaning or maintenance activities:
1. Unplug the device's power cord from the outlet.
2. Let the device cool down.
Cleaning

Use normal glass cleaner and a soft cloth to wipe off the outside casing.

Always be sure to dry all parts completely before plugging the unit back in.

Cleaning frequency depends on the environment in which the unit operates (i.e. smoke, fog residue,
dust, dew). It is important to keep the pump clean after use as snow liquid can be corrosive. Empty
the tank from snow liquid, fill with fresh water and switch on the device to let water run through the
pump system for 1 minute.

Do not immerse the device in any liquid.
V. 02 – 01/12/2016
® Service and Quality Warranty on the last pages of this manual.
HQPE10003
4 tank
5
handle
4 ©Velleman nv