Howard LWL-22-120 Instrucciones De Ensamblaje

LED W L
ork ight
LWL-22-120
assEMBLY instructions
1. Fix the lamp head U-shaped bracket to the H base stand using carriage
bolts, hex nuts, and flat wahers.
2. Toothed gears attached to the support bracket allow the tilt adjustment of
the work light head.
3. Using the handle tilt the fixture head to the desired angle.
4. To turn on the work light, push the on/off switch located at the back of the
work light.
SAFETY PRECAUTIONS
• Do not open the work light body; no user serviceable parts
inside.
• Do not look directly at lighted fixture. Do not remain in
bright light if skin feels warm as you are too close to the
fixture.
• Keep fixture away from children.
• Never use around heavy volatile fluids such as gasoline.
• Never operate the fixture with missing glass safety shield.
• This fixture is not intended for use nor safe to use in
potentially dangerous locations such as places with explosive
or flammable atmospheres.
• Do not handle this fixture when standing on wet or damp surfaces or in water. To reduce the risk
of electrical shock, this light should always be plugged into properly grounded 3-wire outlet. If
used while exposed to wet or damp surfaces a ground fault outlet (GFCI) should always be used.
Do not remove the ground wire or grounded plug from the fixture. Always use a U.L. listed 3 wire
grounded cord with electrical capacity to properly handle this light and other tools you might be
using. Never use light around swimming pool, hot tubs or saunas.
• Use only with an extension cord for outdoor use, cord type:
SW,SW-A,SOW,SOW-A,STW,STW-A,STOW,STOW-A,SJW-A,SJOW,SJOW-A,SJTW,SJTW-A, or
SJTOW,SJTOW-A
• When an extension cord is used with this luminaire, the maximimum cord length shall not
exceed 50 feet (15.2 m) from where the cord exits the luminaire to the receptacle.
Need help? Call 1-800.956.3456 to speak with our installation and product experts.
i i
nstaLLation nstructions
(p) 601.422.0033 | (f) 601.422.1652 | Toll-Free: 800.956.3456
PARTS LIST
• (1) LWL-22-120 Work Light
• (1) Work Light Stand
• (1) Parts Bag
• (2) 1.25"L ¼-20 Carriage Bolts
• (2) ¼" Flat Washers
• (2) ¼-20 Hex Nuts
REQUIRED TOOL
• Adjustable Wrench
580 Eastview Drive | Laurel, MS 39443
www.Howard-Lighting.com
Revised 3/26/2016