CMT ORANGE TOOLS CMT300 Manual De Instrucciones página 13

OPTIOnAL CMT300-T080 And CMT300-T127 TeMPLATe
example of making a drawer with CMT300-T080 and CMT300-T127 template:
Rear
dismantled
drawer
X3
X4
Y4
Y3
Y1
Left-hand Right-hand
side side
Y2
X1
Front
With each machining run, an assembly is made (X1, X2..., Y1
Y2), so, to make a complete drawer, eight machining cycles
have to be carried out.
With these two templates, two types of joints can be made, as
can be seen in the following illustrations.
For the machining, a piece of scrap stock 5mm thicker than the piece to be machines must be placed
horizontally. This piece of wood used horizontally is only used to support the vertical part to be machined.
Wood to be
machined
Scrap stock
13
www.cmtutensili.com