Tabla de contenido
Publicidad
DISPLAY
When you turn on the laser for the first time, it will take some seconds to auto load the built-in show. The
default setting is AUTO EFFECT 1.
First Menu
DMX512
AUTO
(Auto running mode)
Music
(Sound activate mode)
Setting
Testing
ONE BEAM PROTECTION
For safety reason you can switch the One Beam protection On/Off via display. If the One Beam is activated (ON) highly
focused single beam are suppressed. Switch to OFF to deactivate the One Beam protection.
This function should only be turned off by well-trained operator, after checking well all safety aspects!
All manuals and user guides at all-guides.com
The control board offer several features: you can simple set the starting address,
run the pre-programmed program or make a reset. The main menu is accessed
by pressing the Mode-button, browse through the submenu by pressing Up or
Down.
Press the Enter-button in order to select the desired menu.
You can change the selection by pressing Up or Down. Confirm every selection
by pressing the Enter-button.
Second Menu
Third Menu
Running
A001 (DMX address)
Running
Effect 1 (Full show)
Effect 2 ( Only beam)
Effect 3 (only cartoon)
Running
Effect 1 (Full show)
Effect 2 (only beam)
Effect 3 (only animation)
Address
Choose DMX address
OFF
Light
ON
(LCD backlight setting)
ON 5S (ON for 5 sec)
ON 10S (ON for 10 sec)
Press "UP" and "DOWN" to
Cartoon
(Running speed)
choose running speed from
1~99 (Slow to fast)
Master
OFF
(set master unit)
ON
Size
Laser
Colour
(size and colour setting)
Invert X
Invert Y
OFF
One beam
ON
Default
YES
(restore default setting)
NO
Testing picture
Fourth Menu
(Press "UP" or "DOWN" to
choose the size of graphics)
1. Single colour (1~7)
2. RGY
3. RBP
4. GBC
5. RGB
13
Publicidad
Tabla de contenido
