Kenwood KS-308EX Manual De Instrucciones página 5

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Connections
The speaker wires and labels of speakers' back panel are color-coded to facilitate connection. Connect each wire to the matching-
colored terminal, as shown in the figure.
Be sure to turn off your amplifier before connecting or disconnecting speakers.
1. Twist wire's
conductor
Subwoofer (option)
SUB WOOFER
PRE OUT
1. The speaker system's maximum input power is indicated in the specifications. To avoid speaker damage, never run the
speakers at power levels exceeding this limit.
2. This speaker system has a nominal impedance of 8 ohms. To ensure safe and reliable operation, be sure that your
amplifier or receiver is able to work with 8-ohm speakers.
Never short the (+) and (–) speaker wires together.
Do not reverse L and R or (+) and (–) connections. Reversal of sides or polarities may result in unnatural, incorrectly positioned
sound.
2. Push
Right
CROSSOVER FILTER
OFF
ON
VOLUME
MIN
MAX
CROSSOVER
60Hz
200Hz
LINE INPUT
STARDBY / ON
POWER
ON
OFF
(–)
SURROUND
BACK
BS
BROWN
SPEAKERS (6-16Ω)
Speaker terminals
(Amplifier or receiver)
3. Insert the
conductor
Front speakers
Center speaker
(+) Red
(–)
Surround back
speaker
(–)
(–)
Brown
(+)
Wire with white line
4. Release
Left
(–)
White
(+) Green
Right
Left
Surround
speakers
(–)
(+)
Gray
(+)
Blue
(+)
5
EN

Publicidad

Tabla de contenido
loading

Tabla de contenido