Testing, Warranty And Liability; Safety Rules; General Notes On Safety And For The User; Conditions Of Installation And Normal Operation - FPZ SCL K-TS MOR Serie Manual De Instrucciones


Serial no.;

Code of part to be ordered;

Required quantity;

Means of shipment;

TESTING, WARRANTY AND LIABILITY

Testing and inspection

The entire unit is sent to the customer prearranged for installation, after passing the tests and inspections required by the
manufacturer, in conformity with the applicable laws.
Warranty

Warranties are defined in the general terms and conditions of sale.
Liability

FPZ S.p.A. cannot be held liable for operation faults or generic failures caused by improper use of the unit or operations carried out
by persons not authorised by FPZ S.p.A.
9

SAFETY RULES

GENERAL NOTES ON SAFETY AND FOR THE USER

The instructions listed below must be read carefully and become a fundamental part of daily
procedures in the use and maintenance of all the equipment, in order to prevent any kind of
accident, injury or damage.

Do not start the unit until its operation is clearly understood.

If any doubts arise, despite having read this manual carefully and completely, contact FPZ S.p.A.

Make sure all personnel involved in the use of the unit are informed regarding the safety requirements.

Before starting the unit, the operator must check the efficiency of the safety devices and for any obvious defects in the unit. In case
of any defects, immediately notify FPZ S.p.A.

Check the proper operation of all the safety devices every day.

The safety devices must never be removed or disabled.

During maintenance or repair work it may be necessary to exclude some safety devices from the service. This operation must be
carried out by authorised personnel.

Never attempt rash solutions.

All installation, commissioning and maintenance operations must be carried out exclusively by qualified personnel.

Do not modify the electrical connections on the unit.

Do not wear clothes, jewellery or accessories that can get caught in moving parts.

Always keep the area around the unit free of obstructions.

Use appropriate PPE such as boots, gloves, goggles and work clothes.

Pay attention to all danger and caution signs placed on the unit.

Always apply and enforce the safety rules; in case of any doubts, always consult this manual before acting.

The unit must be used only and exclusively for its intended purpose and in accordance with that contractually established with FPZ
S.p.A.
Non-compliance with the unit's intended use can cause serious accidents
The unit must only be started:

In conformity with the purposes of use, transport and handling specified in "FORESEEN USE",

respecting the values given in the "SPECIFICATIONS" and RATING DATA.

CONDITIONS OF INSTALLATION AND NORMAL OPERATION

Startup and operation must occur only under the following conditions:

The unit must be completely assembled and intact, i.e. not damaged or tampered with.

The silencer must be properly connected to the system piping.

The machine must be securely fixed in place.

The motor must be connected to a suitable control panel.

If installed outdoors, protect the unit against the sun and weather.
FPZ-MI-K-TS-MOR-IE2WR-15-R02 31 / 120