Package Contents; Factory Default Settings - Atlantis Professional WebShare 144 WN+ Guía De Inicio Rápida

ENG
Thank You for choosing an Atlantis Product. For more detailed instructions on configuring and using the WebShare
144 WN+, please refer to the online manual on the CD.
1.1

Package Contents

Unpack the package and check all the items carefully. Also, keep the box and packing materials in case you need to
ship the unit in the future. The package should contain the following items: WebShare 144WN+, Power Adapter AC-
DC (12V, 1A), UTP cat. 5 cable (RJ-45 connector), Phone cable (RJ-11 connector), ADSL RJ11 Filter, Quick Start
Guide (English, Italian, French and Spanish), Cd-Rom contained manual(English and Italian), driver and utility,
Warranty Card.
If any item contained is damaged or missing, please contact your local dealer as soon as possible.
1.2

Factory Default Settings

Before you configure this WebShare Wireless N ADLS2+ Router, you need to know the following default settings:
 Username: admin
 Password: atlantis
 IP address: 192.168.1.254
 Subnet Mask: 255.255.255.0
 WAN=PPPoE, LLC/SNAP Bridging, VPI=8, VCI=35
 ESSID= A02-RA144-W300N+, Channel=6, WEP/WPA=WPA2-PSK (AES)
 WPA Pre-shared Key: WebShare144WN+
 DHCP Server: enable (from 192.168.1.100 to 192.168.1.200)
1.3 Cabling
First you must connect the product to the ADSL line through the RJ11 cable you have in equipment (in the port DSL),
then connect to the RJ45 ports the PCs of your Lan or others Switch. You can get to the Wireless Router through the
different client wireless compatible with the IEEE802.11b & IEEE802.11g/n standard. In the end connect the AC-DC
Adapter to the Wireless ADSL2+ Router and then to the socket. Once you've checked all the connections and you've
switched on the Wireless ADSL2+ Router the product will carry on immediately a autotest (60 seconds). Finished
this, the LEDs status will be the following:
LED
PWR
LAN 1-4
WLAN
WPS
USB
DSL
INTERNET
The Led ADSL, if suitably connected, at first will be flashing and then it will remain fixed.
One of the most common causes of problem is bad cabling or ADSL line(s). Make sure that all connected devices are
turned on. On the front panel of your router is a bank of LEDs. Verify that the LAN Link and ADSL line LEDs are lit. If
they are not, verify if you are using the proper cables. Make sure that all devices (e.g. telephones, fax machines,
analogue modems) connected to the same telephone line as your router have a line filter connected between them
and the wall outlet (unless you are using a Central Splitter or Central Filter installed by a qualified and licensed
After the device has turned on, press it to reset the device or restore to factory
default settings. The operation is as below:
 4 seconds or above: restore to factory default settings (this is used when
you can not login to the router, e.g. forgot the password)
Lit green
Lit or Blinking green if any device is connected to the Router
Lit or Blinking green if any device is connected to the Router
OFF
OFF
Lit green
OFF
If the ADSL Led flashes periodically You have to force modulation. Click on
Advanced Setup, then DSL. Choose ADSL modulation, then click on
Apply/Save.
Status
10
ENG